A family of time series curves of the same parameter currently being displayed can quickly be displayedgenerated by EE. Press the Time Series button on the toolbar and then LMC on each cell desiredto be displayed. For all parameters but except for the water depth derived parameters, each time the user selects a new cell the Cell Selection List is updated with the I, the user will be asked if they would like the time series to be displayed. Up to 10 J and K of that cell and the cell location is shown on the model domain as shown in Figure 1. A number is shown next to each cell selected that corresponds to the cell # in the list. There is no limit to the number of time series can be shown at once. Answering "yes" to the loading question
The user may manually adjust the I, J and K value in the list, as well as turn on or off the cell by setting Use to 1 or 0 respectively. Selecting Clear clears the whole list. The user may save and reload a list of time series location for use at a later time using the Save and Load buttons.
Selecting Show causes the time series data to be loaded and displayed for the selected parameter and cells . The user can close the time series and select a new cell, up to a maximum of 10 series. Section 9 in the list. Time Series Graphing provides a discussion of the use and options for the Time Series utility. The user may also the save the series/profile locations for later use with the ALT-O keystroke as well as reload a previously saved series/profile with alt-I.
Toggle the Time Series button to reset the series list or change the view option, the view series is reset. The previously used list of cells is remembered after the user returns the time series option.
| Anchor | ||||
|---|---|---|---|---|
|
Figure 1 ViewPlan: Cell selection for times series plots.