Page Comparison

Figure 1 highlights the The Create a radial grid button in the main toolbar is shown as Create a radial grid#Create a radial grid#Figure 1.

Figure 1. Create a radial grid.

The Once click that button, the Radial Grid form is will pop up as shown in Figure Create a radial grid#Create a radial grid#Figure 2.

Grid Cell in I Direction frame

• Start Angle (deg.): this is the angle in degrees where the grid cell begins.
• Stop Angle : the (deg.): this is the angle in degrees where the grid cell finishesends.
• Angle Increment (deg): the increasing angle in each step.

Grid Cell in J Direction frame

• Min. Radius (m): the radius of the curve inside in meters
• Max. Radius (m): the radius of the curve outside in metersAspect Ratio:
• UTM Zone: this is the Universal Transverse Mercator (UTM) zone, the user can enter the zone number,  number from 1 to 60. When the user enters After entering the location of the focal point, the UTM zone can be updated automatically.
• Location of Focal Point: the longitude and latitude in degrees of the center point in the geographic coordinate system

Figure Create a radial grid#Create a radial grid#Figure 3 presented the generated radial grid. When the grid layer in the layer control is selected, the user can hold holding the focal point is used to move the grid cell. The side point is used to expand or narrow the grid cell along the side. Figure Create a radial grid#Create a radial grid#Figure 4 shows the grid cell after expanding, ; cells are added and have the same size as the previous cells. 

Image RemovedImage Added

Figure 2. Radial grid form.

...