After drawing splines, a Spines layer is added to the Layer Control panel, Select the Splines layer then LMC on a spline in the workspace, it will be highlighted in red. Next, RMC on that spline to display options as shown in Splines Operation 2137882676.
Break Splines: Selecting this option will split the spline into two splines
...
Copy Splines: Selecting this option will copy that spline to other splines layer. After selecting this option, the Select Layer form will pop up as shown in Splines Operation 2137882676. From the drop-down list, we can select <New Layer> or an available splines layer there.
...
| Anchor | ||||
|---|---|---|---|---|
|
Figure 1. Draw splines procedure.
Anchor Figure 2 Figure 2
Figure 2. Copy Spline.